- Welcome to Haoweide Power:
- Cummins Generator Set
- Perkins Generator Set
- Volvo Generator Set
How to Solve the Fault of Filter Element of Generator Set
Date：
2023-01-11 14:02
When the filter element of the generator set has obstacles, the possible obstacles outside the electronic control system shall be inspected first. This can prevent the system sensors, computers, actuators and circuits from being repeatedly and laboriously inspected as an obstacle unrelated to the electronic control system. The real obstacles may be relatively simple to find but not found
Simple before complicated, the possible obstacle parts that can be inspected in a simple way should be inspected first. For example, visual inspection is the most simple, and you can quickly find out some of the more obvious obstacles using visual inspection methods such as looking, touching, listening, etc. Visual inspection method will be explained in the basic way below. When the visual inspection fails to find the obstacles, and you need to use instruments or other special tools and meters to inspect, you should also first inspect the simpler ones
Due to the structure of the filter element of the generator set and the operating environment, some obstacles of the unit may be the most common obstacles of some assemblies or components. These common obstacles should be inspected first. If the obstacles are not found, then the rest of the uncommon possible obstacles should be inspected. This often can quickly find the obstacles, saving time and effort
The electronic control system of the filter element of the generator set usually has obstacle self diagnosis performance. When the electronic control system has some obstacle, the obstacle self diagnosis system will immediately detect the obstacle, and alarm or remind the operator through the "monitor the engine" and other warning lights. At the same time, store the signal of the obstacle in the form of code
For some obstacles, before the inspection of the diagnosis system, the obstacle code shall be read according to the way submitted by the manufacturer, and the obstacle parts referred to by the code shall be inspected and eliminated. After the obstacle parts referred to by the obstacle code are removed, if the engine obstacle phenomenon has not been removed, the possible obstacle parts of the engine shall be inspected if the transmission of the obstacle code starts
Think before you act to analyze the obstacles of the generator set, and perform obstacle inspection on the basis of being familiar with the possible causes of the obstacles. In this way, the blindness of obstacle inspection can be prevented. Neither ineffective inspection can be conducted on the parts unrelated to the obstacle, nor can the failure to quickly remove the obstacles due to missing inspection on some relevant parts
The performance of some components of the electronic control system used after standby and the normality of the electrical circuit are often inferred from their voltage or resistance values and other parameters. Without these data, the system's obstacle detection will be very troublesome, and the system can only be replaced by new parts. These methods occasionally cause a sharp increase in maintenance fees and time-consuming work
